zur Trennung der Schaltzüge auf
Höhe der Tretlagerstütze.
Somit kann oben die spiralverstärke Schaltzughülle verwendet werden und unten die längsverstärkte Schaltzughülle.
Battery for Shimano DI2 shifting systems
*****Dangerous materials notice: UN 3480, lithium-ion batteries, 9, (E); Packaging: 4G box, cardboard; Quantity per transport category: 1 kg = 4 points (value) *****
When converting to the stick battery, the following additional parts are required:
- Charger for stick battery Di2
- stick battery Di2 battery holder
for Shimano Gen. 2 battery management
suitable for installation on Husk-e with EP6 motor,
center button to switch between automatic/manual
without cable
for the primary drive on the Husk-e.
The chain length always depends on the position of the bottom bracket and the number of teeth on the chainring.
It may be necessary to shorten the chain by a few links.
Chain from the bottom bracket to the motor / Pinion gearbox.
Incl. a chain rivet pin to connect the chain.
for connecting first generation DI2 cables (Ø4.9mm connector) with second generation cables (Ø3.4mm connector).
Required for connecting older components with the EP8 system.
consisting of:
- 1 inner shift cable 1.2 mm
- 1 end cap 1.2 mm
- Outer cable cover, longitudinally reinforced 1500mm
- Spiral-reinforced outer cable cover 1000mm
- 2 end caps 6mm
- 2 end caps 4mm
- 1 Intermediate sleeve shift cable
- Cable tie. 4 pcs.3.5x150 mm
- Cable ties. 2 pcs.2,5x98 mm
incl. intermediate sleeve for separating the shift cables at the height of the bottom bracket support.
This means that the spiral-reinforced cable housing can be used at the top and the longitudinally reinforced cable housing at the bottom. This reduces the required shifting force while maintaining stability in the required range.
Button and support level switch on the handle
always require a support cable, as the thin
Di2 cable is too unstable.
This article is required if no support cable is available.
It contains all the materials required for a dummy cable.
The spring with a length of 160mm must be glued into the bottom bracket holder at the Husk-e.